Follow the Directions below to change the unit of measurement on the C3D Pedometer. 

Choosing Imperial Inches will show Miles on the Pedometer, while choosing metric CM will show Km on the pedometer. 


The C3D Pedometer will exit the programming mode if 10 seconds pass without a button press. If you make mistake or it exits the programming mode, you can simply restart programming.

When Clock format is set to 12H, the screen will only display PM, for AM hours, AM is not shown. 


Step 3: Programming the C3D Pedometer

  • Press MODE until you see on the top of screen

  • PRESS & HOLD SET until the display shows the icon SETUP and the digits start to blink

  • PRESS SET to save clock format and enter clock setting mode

  • PRESS SET to save hour and adjust minutes

  • PRESS SET to save minutes and choose unit of measurement

  • PRESS RESET  to toggle between IN (Imperial) or KG (Metric) units [see fig. 2a]



  • PRESS SET to save units and enter stride setting mode
  • PRESS SET to save stride and enter weight setting mode
  • PRESS SET to save weight and enter step target mode
  • PRESS SET to save daily step target.


Congratulations your C3D pedometer is ready to go!



View & Buy OZO Fitness Pedometers at: