How do I CLEAR and Restart from the beginning? (SC 3D Pedometer)
Modified on: Thu, 20 Feb, 2020 at 12:12 PM
If you would like to restart the programming of your pedometer and would like to start fresh or start over. Meaning return the pedometer back to factory defaults and start your programming from the beginning. Follow the directions below.
NOTE: This isn't required, you can go through the programming sequence again and just change whatever value you want to change.
Caution: Doing this will erase all data.
You will need to slide off the back clip, then
Gently insert the end of a paper clip or toothpick into the hole on the back of the pedometer, this will reset the pedometer back to factory defaults
Follow the directions below to re-program your pedometer
Begin programming on the Step Screen
Click the WHITE button until you see the word ‘Step’ in the top left corner and the clock below the line. Just like you see in the image below.
If 30 seconds elapses without a button press, the pedometer will exit the setting sequence.
Programming sequence runs forward only, if a mistake is made, you can easily go back and change it.