If you would like to restart the programming of your pedometer and would like to start fresh or start over.
Meaning return the pedometer back to factory defaults and start your programming from the beginning. Follow the directions below.
NOTE: This isn't required, you can go through the programming sequence again and just change whatever value you want to change.
Caution: Doing this will erase all data.
- You will need to slide off the back clip, then
- Gently insert the end of a paper clip or toothpick into the hole on the back of the pedometer, this will reset the pedometer back to factory defaults
- Follow the directions below to re-program your pedometer
Begin programming on the Step Screen
Click the WHITE button until you see the word ‘Step’ in the top left corner and the clock below the line. Just like you see in the image below.
- If 30 seconds elapses without a button press, the pedometer will exit the setting sequence.
- Programming sequence runs forward only, if a mistake is made, you can easily go back and change it.
- Tool to Calculate your stride length: www.ozofitness.com/Stride, for more accurate distance tracking
Setting the Clock
- Start programming on the Step screen as shown above
- PRESS & HOLD WHITE button, ADJ will Flash
- Release WHITE button when you see 12Hr or 24Hr Flashing
- PRESS BOTTOM Button to toggle between 12HR for (AM/PM) or 24HR (13:00)
(Once the desired format 12HR or 24Hr is Flashing)
- PRESS WHITE Button to save
Setting the Hour and Minutes
- PRESS BOTTOM button to advance Hour to correct time
- PRESS WHITE button to save
- PRESS BOTTOM button to advance Minutes to correct time
- PRESS WHITE button to save
- PRESS BOTTOM button to zero out seconds
- PRESS WHITE button to save
Set the Date
If you are only tracking steps, place the pedometer on a table for 1 minute, after setting the year.
This will exit the programming sequence and then your pedometer is ready to use.
- PRESS BOTTOM button to advance Month to correct month
- PRESS WHITE button to save
- PRESS BOTTOM button to advance Day to correct day
- PRESS WHITE button to save
- PRESS BOTTOM button to advance Year to correct Year
- PRESS WHITE button to save
Set your Stride Length
If you advance your stride length too far, you can continue advancing past the max 84"/ 213 cm to start over and set the stride length you desire.
- PRESS BOTTOM Button to toggle between I (Inches) or C (Centimeters)
Once the desired Unit of Measurement I or C is Flashing
- PRESS WHITE Button to save
- PRESS BOTTOM button to advance Stride Length to correct length
- PRESS WHITE button to save
- PRESS BOTTOM button to advance Weight to correct weight
- PRESS WHITE Button to save
Set your Daily Step Target
- PRESS WHITE button to move to second Digit
- PRESS BOTTOM button to advance Digit to desired number
(if 10,000 steps, change to a 1, if less than 10,000 change to a zero) - PRESS WHITE Button to save
- PRESS BOTTOM button to advance Digit to desired number
- PRESS WHITE Button to save
- PRESS BOTTOM button to advance Digit to desired number
- PRESS WHITE Button to save & exit set up
Your daily step target progress is shown with the vertical bar on the left side of the screen, the closer you get to your goal the closer it gets to the top of the screen.
Congratulations your Pedometer is Set!
VIDEO Instructions for programming:
Step 1 - Activate your Pedometer - Remove battery insulator strip from back of pedometer.
Step 2 - Follow-along video to program your pedometer.
Press WHITE button to navigate between screens.
 |  |
Questions? help@ozofitness.com
Next go Watch a Video on using the Functions of your New Pedometer.
View & Buy OZO Fitness Pedometers at: