|Watch Video||Activate the Pedometer|
|Watch Full Setup Video Walk-through|
Visual Instructions below.
Press the TOP button to navigate between screens.
* The programming sequence runs from start to finish, if you make a mistake on one of the settings, you can easily go back and change it later.
** If 30 seconds elapses without a button press, the pedometer will exit the setting sequence. Should that happen just follow the steps to start the programming sequence again.
*** You can find your stride length here: www.ozofitness.com/Stride, if you are using your pedometer to track distance it is best to know your stride length before starting.
Begin Programming, with Pedometer on the Step Screen.
It shows Step in top left of screen and the clock below the line.
Set Clock Mode
12Hr for AM / PM
24Hr for 13:00
Only tracking steps?
You can stop after setting the date.
Set Stride & Weight
'I' (Inches) or 'C' (cm)
Only need if Tracking Distance & Calories
Set Daily Step Target
Only tracking steps, place pedometer on table for 1 minute after setting the year. Then it is ready to use.
Congratulations!! Your SC 3D Pedometer is all Setup and Ready to Go
Next go Watch a Video on using the Functions of your New Pedometer.