SETTING CLOCK ON the SC 3D PEDOMETER (Takes just a few minutes)



Written instructions below.


Press the TOP button to navigate between screens.





IMPORTANT NOTES: 

* The programming sequence runs from start to finish, if you make a mistake on one of the settings, you can easily go back and change it later.

** If 30 seconds elapses without a button press, the pedometer will exit the setting sequence. Should that happen just follow the steps to start the programming sequence again.

*** Your Pedometer is pre-programmed to reset to zero at midnight daily. It is important to get your clock set correctly to avoid resets at noon.


Begin Programming, with Pedometer on the Step Screen. 
It shows Step in top left of screen and the clock below the line.


Set Clock Mode
12Hr for AM / PM
24Hr for 13:00
Set Time
Once the time is set, place the pedometer on a table for 1 minute. Then it is ready to go.




Congratulations, your clock is set!


Questions? help@ozofitness.com