1) A follow-along setup video for your Pedometer (under 4 minutes)
2) A how to get the most accurate results on your Pedometer video
The Clock on the SC1 Pedometer needs to be set in the 12h format. Once set, advance to the desired hour. Only the pm is shown on the clock, so if you don't see PM beside the hour you are in the AM hours. Advance the clock forward until you see PM show up to set a PM hour. See below instructions on setting the clock.
SETTING CLOCK ON SC1 PEDOMETER
In “STEP” mode, press & hold “SET” until the display shows the icon “SET” and the digits start to flash
If your unit is asleep, press MODE button to wake it up first, then press & hold “SET” until the display shows the icon “SET” and the digits start to flash.
Hold SET till screen flashes to enter setting sequence:
Press RESET to Toggle between 12 or 24 Hours clock format preference
Press SET to save your preference and move to Clock Setting
Press RESET to select hour to your desired time (it should be flashing)
Press SET to save hour and move to select minute (it should be flashing)
Press RESET to select your desired minute time
Press SET to save minute
Press MODE or leave unit idle for approx. 10 seconds to exit