It is easy to go back and change a setting if you wish.  

For example: Let's say you entered the day incorrectly for the date. 
You could simply re-enter the programming sequence and go in and change just the day
without changing any other values you had already entered correctly. 

See example

Press the TOP button to navigate between screens.


* The programming sequence runs from start to finish, if you make a mistake on one of the settings, you can easily go back and change it later.

** If 30 seconds elapses without a button press, the pedometer will exit the setting sequence. Should that happen just follow the steps to start the programming sequence again.

Begin Programming, with Pedometer on the Step Screen.  
It shows Step in top left of screen and the clock below the line as shown above.

In fact, all you need to do for each setting that is correct, is Press the TOP button to save and move to the next setting.

In our example, we are only trying to change the day in the date. 

Assuming the clock setting is correct, continue to Press the TOP button for each value to save it and move onto the next.

On the date setting, assuming the month is correct, Press the TOP button to save it and move onto Day.

In our example, we needed to change the day, so Press the BOTTOM button until we arrive at the right Day. Then Press TOP to save and move on. 

At this point, since everything else in our example was correct, just place the pedometer on a table for 1 minute.

After 1 minute it is ready to use.

Congratulations!! Your SC 3D Pedometer is all Setup and Ready to Go

  1. Download a large print comprehensive product manual including a troubleshooting section.

Make sense? If not send us an email at and we would be happy to assist you.